Multi‐Material 3D Printing of Soft Dielectric Actuators With Optimized Electrodes

Dielectric elastomer actuators (DEA) have gained increased attention in the design of electrically driven soft and lightweight robotic devices. They rely on Coulomb forces for their actuation and are able to undergo large displacements as a function of the applied electrical field. Fabricating DEAs with additive manufacturing opens the way to a personalized and cost‐efficient fabrication of soft active devices. In particular, extrusion‐based techniques provide a versatile strategy to multi‐material 3D print DEAs by using electrically conductive and soft filaments with high elongation. One key aspect of DEAs is the electrode's performance, which has to provide a high electrical conductivity and a good adhesion to the sandwiched membrane. Herein, selected 3D printing parameters were varied to optimize the electrode infill density and electrode infill direction. Mechanical and electrical properties, as well as actuation performance, of fully 3D‐printed DEA demonstrators were studied comprehensively. With the optimized parameter set, a maximum DEA displacement of 91% was achieved with respect to the free length of the actuator. This is comparable to the performance of non‐3D‐printed DEAs and demonstrates the potential of 3D printing for the production of DEAs undergoing large deformations while leveraging the design and manufacturing freedom of multi‐material 3D printing.