Answers are grounded in this paper and cite their sources.
Computational simulation reveals mist enhances film cooling effectiveness in gas turbines, suggesting droplet dynamics influence performance.
The sweeping jet has the potential for use in film cooling over gas turbine airfoils due to its ability to spread wider, providing a more uniform lateral film cooling effectiveness. The sweeping jets are provided through fluidic oscillators without using any moving parts, making them attractive as a passive uniform cooling scheme. In this study, mist was added to the sweeping cooling flow to enhance film cooling performance further. The computational simulation was conducted to study mist behavior in sweeping jet film cooling, focusing on how different droplet boundary conditions affect film cooling effectiveness and droplet dynamics during phase change. Three droplet wall boundary conditions—reflect, wall-film, and trap—were implemented. Additionally, droplet sizes and blowing ratios were studied, including 10 μm, 20 μm, and nonuniform Rosin-Rammler diameters (1–40 μm) with a 10% mist ratio. Two blowing ratios, BR=1 and 2, were applied. The results indicated that adding mist significantly enhanced film cooling effectiveness along the centerline, with the Wall-film and Reflect cases using uniform 20 μm droplets showing average cooling effectiveness improvements of approximately 130% and 100%, respectively, compared to the air-only case at BR=1. The findings indicated that under low-temperature lab conditions, the wall-film boundary condition better reflected observed liquid streaks in the experiments than the reflect boundary condition. The fluidic oscillator was evidenced to promote droplet coalescence through vortex formation, recirculation, and feedback mechanisms, producing larger droplets at the jet exit. These droplets traveled farther, extending cooling coverage downstream where air-only film cooling proved ineffective. Moreover, the sweeping vortex’s centrifugal force drove larger droplets outward, while smaller ones stayed in the central region of the vortex, where evaporation was accelerated by negative gage pressure, leaving no droplets in the vortex core. In the domain up to x=28d, 64.2% of droplets evaporated under the wall-film and 78.5% under the reflect conditions with 20μm.
No takes yet. Share an insight, caveat, or question.
Kojidi et al. (2025) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: