Answers are grounded in this paper and cite their sources.
The performance of aluminium-manganese alloy in sea water environment has been evaluated by submerging the alloy produced at varying Mn input range: 1- 4 wt % into a 99% purity aluminium powder. It was observed that increased concentration of Mn in Al-Mn alloy (1-3%) resulted in increase in corrosion rate of the alloy (in presence of sea water) due to the strong affinity between aluminium and oxygen which enabled oxygen to significantly oxidize aluminium, forming oxide films. This implied that oxide film formation occurred simultaneously with corrosion attack. A model was derived to predict the alloy exposure time based on its initial weight and corrosion rate in the same environment. The validity of the derived model; Txp = - 5638.5 ɤ 2 – 64.35 β2 + 125.29 ɤ + 2.9279 β – 0.653 was rooted on the core expression Txp + 0.653 = - e1 ɤ 2 – e2 β 2 + e3 ɤ + e4 where both sides of the expression are correspondingly approximately equal. Comparative statistical analysis of results from a standard model (regression model) derived model and experiment shows that the standard error in predicting the alloy exposure time for each value of the initial weight and alloy corrosion rate are 3.6752 x 10-5 & 0.017%, 0.0096 & 0.0217% and 0.0084 & 0.0203% respectively. Similarly, the F-test results are 2.47 x 10-5 & 0.3471, 2.29 x 10-5 & 0.3298 and 2.01 x 10-5 & 0.3024 respectively. Furthermore the correlation between exposure time and corrosion rate & initial weight as obtained from experiment, derived model and regression model were all > 0.97. Computational analysis of results generated from regression model, derived model and experiment shows that the depths of corrosion penetrations are 9.5288 x 10-4 , 9.8728 x 10-4 and 9.89 x 10-4 mm respectively. Deviational analysis indicates that the maximum deviation of the model-predicted alloy exposure time from the corresponding experimental value is less than 14.58%. This translated into over 85% operational confidence for the derived model as well as over 0.85 reliability response coefficient for the dependence of the alloy exposure time on corrosion rate and initial weight of alloy.
No takes yet. Share an insight, caveat, or question.
Nwoye et al. (2024) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: