Key points are not available for this paper at this time.
Due to the 2050 Net Zero Emissions becoming a major goal worldwide, electric vehicles have emerged as the future mainstream products. Among them, copper foils play a crucial role as the anode current collector in lithium-ion batteries (LIBs). Enhancing the strength and decreasing the thickness of copper foil are both important factors improving the lifespan of LIBs. The thickness of Cu foils can be reduced by rolling copper sheets, but it is challenging to achieve the required thinness below 10 micron for electronic applications. Direct current electroplating not only effectively increases the deposition rate but also reduces costs for thin Cu foils. In this study, we utilized a rotary direct current Cu-Ni co-electroplating method to enhance the mechanical strength of nanotwinned copper. The ultimate tensile strength (UTS) of nanotwinned copper-nickel alloy reached over 847.3 MPa (an increase of approximately 12.6 % compared to the maximum UTS of nanotwinned copper, which was 752.8 MPa) while maintaining excellent electrical conductivity similar to nanotwinned copper. Through potentiostat analysis, it was discovered that nickel ions inhibit copper growth, causing the reduction potential of copper to shift negatively, resulting in a decreased deposition rate and increased twin density. The nickel content, measured by ICP-MS, was found to be 0.467 ppm, suggesting that nickel acts as an impurity that refines grain size in copper foils. Therefore, this method not only significantly improves the strength of copper foils but also maintains low electrical resistance and low-cost characteristics. It provides a new material option for the anode current collector of the next-generation LIBs. Figure 1
Ping et al. (Fri,) studied this question.