Key points are not available for this paper at this time.
This research aims to evaluate the effect of porous filter configuration on flow characteristics within filter using CFD simulation. This simulation model was chosen for comprehensive analysis that considers different variables affecting the filter performances. Dynamics of the flow and pressure drop under different flow conditions and filter geometry were studied. The Euler-Lagrangian approach was used to model multiphase flow, and the standard K-ε model was used for turbulence characterisation. Particle size distribution was characterized using Rosin-Rammler distribution. The initial status of these properties was obtained by previous experimental references and their evolution over time was simulated at the cell level of the model using User-Defined Functions (UDF). The main conclusions of the study are: i) The pressure drop increased with flow rate and thickness of the filter but decreased with increasing filter length and diameter. ii) There is no significant change in velocity ratio with the distance from the filter inlet at the filter centre line except the first 5% from the inlet and last 5% close to the end. iii) it was identified that higher radial velocity ratios imply a less particle deposition within the filter media. The results also shows that the particle loading on 290 mm filter is 50% - 60% lower than the other filters but evenly distributed across the filter. However, the pressure drop decreased with the filter length. 55mm filter that has the highest radial velocity ratio performs poorly in particle trapping.
Rukshan et al. (Fri,) studied this question.