The Result of Electrical Resistivity Investigation of Solid Waste Landfill Conducted at Nsukka Municipality Using Electrical Resistivity Measurments

Solid waste landfill management has been a significant issue for Nigerian urban areas and other developing countries across the globe. Similar to most other cities, Nsukka also generates waste on a daily basis, much of which is dumped in poorly designed and positioned dumping sites. The majority of the disposal sites are found on roadsides, at marketplaces, on farms, and in residential neighborhoods, among other places. The road infrastructure and groundwater are under danger, and the beauty of the impacted communities are not spared. Undoubtedly, the unchecked citation of boreholes as the source of potable water in the majority of our rural and urban communities—given that the government doesn't seem to be providing water to the people—has become a significant challenge. An investigation using electrical resistivity method was conducted around a solid waste dumpsite at Nsukka in Nsukka L. G. A of Enugu State, Nigeria with an aim to investigate the level of groundwater contamination and the objectives to determine the subsurface geoelectric layers, depth to water table, lithology delineation and map out the contamination zones. The scope of this study provides an overview of some of the approaches used to assess the aquifer vulnerability and aquifer potential using Vertical Electrical Sounding (Schlumberger array) and 2D resistivity imaging (Wenner array) in different locations around Nsukka municipality dumpsite. Both methods were used for this study in order to provide a geophysical database for exploration of the study area’s groundwater resources and also they are less expensive and less time consuming. VES has proved to be effective in solving groundwater problems in most places in Nigeria (Ezeh and Ugwu, 2010; Ugwu and Ezeh, 2012; Nzemeka et al. 1, 2. Electrical Sounding (VES) and 2D resistivity imaging were carried out with a digital read out resistivity meter (ABEM SAS 1000) to acquire data in the area and were interpreted using the Schlumberger automatic INTERPEX analysis software and the RES2DINV software respectively, which generates model curves using initial layer parameters and display the variations of electrical resistivities respectively. A total of eight (8) sounding and six (6) 2D resistivity imagings were carried out in the area. A contaminant leachate plume was delineated in 2D resistivity sections as low resistivity zones while the VES shows the depth of aquifer. In 2D pseudosections where bluish colours with low resistivities (less than 20. 80\ (\) m) with the depth ranging from 1. 28m to 17. 1m in the Line 1 and 2 are seen as contaminated zones. The rest of the lines are not contaminated because of their high resistivities (greater than 20. 80\ (\) m). The result of the electrical resistivity survey also showed 4 - 5 layers geo-electric sections and an AA and AK type sounding curves. The VES result shows that VES 1A, 1B, 2A and 2B which are carried out on line 1 & 2 of the wenner lines showed signs of contamination with low resistivity values less than 20. 80\ (\) m complementing the wenner results. The contamination has not yet got to where the aquifer is located on the lines. Since the depth to the aquifer ranges from 30. 26m to 155. 43m while maximum depth of contamination is 17. 1m. It is believed that the leachate has not percolated down to the aquiferous zones as such aquifers are presumed to be free. As such, it is recommended that boreholes around the study area should not be less than 30m deep to avoid exploiting polluted water.