Answers are grounded in this paper and cite their sources.
There are different approaches for CFD simulation of effusion-cooled surfaces, such as the 1D Porous Jump Coefficient and periodic boundary conditions. These methods are used to minimize the cost of simulation; however, each model has its own drawbacks. A novel approach called the “Slot Method” has been introduced for the first time in this research. In this method, based on the porosity of the effusion patches, the effusion holes are replaced by a limited number of slots to reduce the cost and time of simulations. The slot method is simulated using the Reynolds-Averaged Navier-Stokes (RANS) methodology to predict the pressure recovery performance of the diffuser, pressure distributions on the walls, outflow velocity distributions, and outflow temperature distributions. The CFD simulations are compared to experimental data from a rectangular S-duct diffuser as well as CFD simulations with 1D Porous Jump Coefficient boundary conditions reported by NG [1]. Four different numbers of slots are simulated using RANS k-ε models to investigate the effect of the number of slots on the main and secondary flows. The simulations show that the higher number of slots has the potential to mimic the behavior of the effusion holes. The simulations exhibit significantly more accurate predictions compared to the 1D Porous Jump Coefficient in terms of pressure recovery performance in the diffuser. Some discrepancies between the experimental data and the Slot Method in the outflow velocity distribution can be attributed to imprecise boundary conditions in the reported experimental data.
No takes yet. Share an insight, caveat, or question.
Moradi et al. (2024) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: