Answers are grounded in this paper and cite their sources.
Determination of minimum horizontal stress (Sh) and its alteration with reservoir pressure (or stress path) is critical for efficient drilling, completion, production, intervention, and reservoir management. A comprehensive method is developed to constrain stress path for both depletion and re-pressurization by integrating the actual field mini-frac and rock mechanics laboratory pore volume compressibility (PVC) test data. PVC test demonstrates that the stress path decreases with depletion. Field data from three reservoirs in Gamma Field and one reservoir in Delta Field in deep-water wells in the Gulf of Mexico (GoM) show that stress path measured from PVC test agrees very well with the stress path defined from minifrac tests. Therefore, it can be used to predict Sh for depleted sand. The calculated stress path for re-pressurization shows that the higher the stress path for depletion, the higher it is for re-pressurization. The most likely stress path is 0.66 for depletion and 0.56 for re-pressurization for Reservoir B and 0.70 for depletion and 0.61 for re-pressurization for Reservoir C. The results from this study have been used to determine the depleted sand fracture gradient for drilling and operation pressure limit for well intervention. INTRODUCTION It is critical throughout the various phases of drilling, completion, production and intervention to understand and predict the evolution of reservoir pressure and in-situ stresses especially when production is ongoing, and the reservoir becomes progressively depleted. Stress path is introduced to evaluate how the in-situ stresses change with reservoir pressure variation. There are three stress path parameters that relate to the three principal stresses, overburden (Sv), maximum horizontal stress (SH) and minimum horizontal stresses (Sh) to reservoir pressure alteration (Sayer, 2006, Zhang et al. 2021a & 2021b). Stress path for Sh is discussed in this paper. Stress path can be measured in the lab by running pore volume compressibility (PVC) tests. Through various methods of loading and unloading, there are three types of PVC tests that can be conducted: "true" depletion, effective stress, and rate type compaction method (RTCM). Zhang et al. (2021a) found that the Sh calculated by using the stress path measured from PVC tests matched very well with the minifrac and drilling losses data from two fields in deep water Gulf of Mexico. It is also discovered that "true" depletion method is more accurate when compared to effective stress and RTCM methods. This observation seems to agree with the physics of the test.
No takes yet. Share an insight, caveat, or question.
Zhang et al. (2024) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: