Answers are grounded in this paper and cite their sources.
Rock masses are subjected to simple shear mode deformation during earthquake. Currently, there is no standardized simple shear test method for rocks in Japan. The authors propose a new test method, the simple shear test of a prismatic rock specimen using torsional shearing. In this test, prism specimens are radially installed on the pedestal, the cap is placed on the specimen tops, and then specimens are torsionally sheared by a torque with fixed axial displacement of the cap. In this study, to investigate the influence of radial shear load distribution by the applied torque on stress-strain relationships, proposed tests were conducted by varying the length/width ratio of the prismatic Berea sandstone specimens from 1 - 2.5. The results demonstrated that the more smooth stress-strain relationship, the shorter specimen length. On the other hand, the longer specimens showed more complex failure modes, and the strain decreased with increasing torque and did not increase monotonically. 1. INTRODUCTION Rock masses are subjected to simple shear mode deformation during earthquake. Currently, there is no standardized simple shear test method for rocks in Japan (Japanese Geotechnical Society, 2015). Since heterogeneity and anisotropy predominate in rock masses (Togashi et al. 2018; 2021a; 2021b), the deformation mode applied in loading tests has a significant influence on the mechanical behavior of rock masses. Therefore, it is necessary to test the appropriate loading mode for each event, and simple shear mode tests are necessary for rock deformation during earthquake. Torsion tests on rock have been conducted in a small number of cases (Talesnick and Ringel, 1999; Paterson and Olgaard, 2000). In these tests, the end face of the specimen and the cap were rigidly bonded with adhesive and subjected to high cell pressures of 10 - 50 MPa to transfer shear load. However, using an adhesive strong enough to withstand the shear load of the rock may damage or deteriorate the cap and pedestal. It may not be reusable. It is not suitable for studies where multiple tests are essential, such as estimating failure criteria. The authors propose a new test method, the simple shear test of a prismatic rock specimen using torsional shearing as shown in Fig. 1 (Togashi et al. 2023). In this test, prism specimens are radially installed on the pedestal, the cap is placed on the specimen tops, normal load is applied to the specimen, and then specimens are torsionally sheared by a torque with fixed axial displacement of the cap. This method enables the reproduction of the simple shear mode deformation experienced by rock masses during earthquakes. Additionally, it is possible to replicate arbitrary rock mass conditions by varying the normal stress.
No takes yet. Share an insight, caveat, or question.
Sato et al. (2024) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: