Answers are grounded in this paper and cite their sources.
This work aims to investigate the influence of temperature variation on the formation breakdown gradient in scenarios of annular pressure build-up (APB) mitigation during well production. In subsea well projects, it is common to mitigate the effect of APB through the open shoe method, which involves allowing formation fracture below the casing shoe. In this analysis, the fracture gradiente obtained through leak-off tests conducted in the field is typically used. However, the breakdown pressure tends to be higher than the fracture gradient and can be further augmented by temperature increase, potentially resulting in undersizing of well structure elements and eventual integrity failure. To assess the potential implications in well design, a 1D geomechanical model was developed, and thermo-hydraulic simulations were conducted for two wells located in the Brazilian coast. Then, the breakdown gradient calculations were performed, considering variations in pressure and temperature in the confined annuli, primarily comprising shale layers. As a result, variations of up to approximately 19% were observed in the breakdown gradient. Significant reductions in the casing safety factors were observed for the analyzed wells, approximately 37% reduction in the burst safety factor and 25% in the triaxial safety factor. 1. INTRODUCTION The Theory of Thermo-Poro-elasticity has been widely discussed and presented in various wellbore stability and reservoir stimulation works. The stress concentration around the borehole is strongly affected by temperature. In scenarios of narrow drilling windows, for instance, cooling induced by fluid circulation can lead to losses to the formation due to the reduction in stress concentration, and consequently, the breakdown pressure (as well as the collapse pressure). Conversely, heating tends to increase the breakdown pressure. Rizvi et al. (2022) presented some case studies where the bottom hole temperature was affected by operational drilling parameters variation leading to fluid loss. The same effect is described in many others works (Maury and Idelovici, 2015, Li et al, 1998, Liu and Zhu, 2018, Tao and Ghassemi, 2010). As a point of view from reservoir stimulation, Azevedo et al. (2023) demonstrated that the minor in situ horizontal stress can be reduced by cooling of the rock during cold fluid injection through numerical analysis and evidence of field cases.
No takes yet. Share an insight, caveat, or question.
Souza et al. (2024) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: