Answers are grounded in this paper and cite their sources.
Metallurgically Clad Pipes (MCP) have a strong bond between the outer pipe and the liner, effectively avoiding the separation failure of Mechanically Lined Pipes (MLPs). The girth weld position in an MCP becomes the weakest point of the entire pipeline. In this study, a three-dimensional bimetallic model with a girth weld is established, considering factors such as weld reinforcements, weld bottom width, weld groove angle, misalignment value, heat-affected zone width, and material properties of the girth weld and heat-affected zone. The influence of different working internal pressures and bending moments on the load-bearing and strain capacity of MCP under combined loads is investigated. With the increase of working internal pressure, stress concentration and plastic deformation occur in the heat-affected zone of the metallurgical clad pipe with girth welds. The stress level at the weld location is relatively low. An appropriate working internal pressure can effectively improve the load-bearing capacity of MCP, which allows it to withstand larger bending loads. Increasing the bending moment, the stress at the girth weld and heat-affected zone significantly increases, resulting in plastic deformation and a decrease in the overall load-bearing capacity of the pipeline. Considering pipe failure, the bending moment within the combined loads assumes the most critical role. It is concluded that for the MCP under combined loads, the overall stress level is lower at the girth weld, while the heat-affected zone experiences higher stress which may become the main location of failure. The present research results can provide a theoretical basis for the design, manufacturing, and safety assessment of MCP.
No takes yet. Share an insight, caveat, or question.
Yang et al. (2024) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: