Numerical investigation and performance comparison of UAV propeller with varying duct configuration

Purpose The purpose of this study is to investigate the effects of propeller thrust with two different duct configurations. Propellers in a quadcopter play an indispensable role in generating the necessary thrust and torque to keep the drone flying and manoeuvring. Based on the specific purpose of the unmanned aerial vehicle, both the altitude and attitude can be varied by the amount of thrust produced. Design/methodology/approach This paper deals with the generation of three numerical models such as plain rotor, rotor with fixed duct and rotor with rotating duct and the comparison of their amount of generated thrust. The plain rotor numerical analysis was compared with the experimental results. The rotor taken for the analysis was 15 mm*5.5 mm TAROT 650. Thrust was measured for all models at four different angular speeds, such as 2,500 rpm, 4,000 rpm, 5,500 rpm and 7,000 rpm. Findings Due to the suction pressure gradient on the duct inlet surface, the additional amount of lift is produced, and it is the best way of increasing propulsion efficiency and its aerodynamic performance as it reduces the tip loss at the tip of the propeller. The turbulence model taken for the numerical analysis was k − ε . Originality/value The rotating duct is expected to provide additional thrust by the increased upward force due to the rotation of duct. The rotating duct produced the optimal results between the plain model and ducted model. At the highest speed of 7,000 rpm, the ducted propeller produced 24.97 N, and the rotating duct propeller produced 23.89 N, whereas the plain propeller produced 23 N thrust. Nearly 8.6% of the thrust improvement is observed in duct and 3.87% in rotating duct.