Answers are grounded in this paper and cite their sources.
One of the most common problems of bead mills is the intensive wear of their working grinding segments, which negatively affects the quality of the crushed material and causes long-term downtime of the equipment, and, as a result, economic losses. Taking into account the identified problem, the purpose of the study is to analyze the working conditions and the nature of wear of the working surfaces of the segments of the bead worm shaft and justify the technology of their restoration. It was established that the main wear of the contact surfaces of the cast iron segments (ChKh1) is caused by their friction with the beads, which according to their chemical composition (55 % SiO2, 19.3 % СaO, 13.4 % Al2O3, 6.5 % B2O3, 4.2 % MgO) and hardness are an abrasive element relative to wearing surfaces. The nature and degree of loss of size and shape of the segments due to wear depends, among other things, on the diameter of the bead balls, which determines the waviness of the contact surface of the segment and the gradient of hardness values due to defamation. On the other hand, the working surfaces are affected by the technological suspension, which causes the appearance of the effect of cavitation wear, which consists in the formation of indentations on the surface after multiple repeated blows of the liquid. The conducted analysis of the operating conditions of the segments established a combined hydroabrasive wear mechanism of their working surfaces, which is explained by the simultaneous effect of abrasive bead elements and technological suspension. The nature of the intensity of the mentioned wear mechanism is uneven along the height of the worm screw, from mainly hydroabrasive for the upper segments to almost purely abrasive for the lower segments. Taking into account the determined mechanism of wear, it is proposed to restore the working surfaces of the segments by electric arc surfacing, and powder-coated wires of different chemical composition are used as surfacing materials. To clarify the influence of the chemical composition of the deposited metal on the mechanical properties of the restored layer, it is proposed to use powder-coated wires with different contents, primarily of carbon and chromium, which will allow to evaluate the resistance of the contact surfaces to both abrasive and hydroabrasive wear.
No takes yet. Share an insight, caveat, or question.
Herasimov et al. (2024) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: