Answers are grounded in this paper and cite their sources.
Polymer injection projects need to reduce CO2 emissions, material demand for facilities, water use, and waste to compete as viable solutions in the energy transition. Steel production process is the main contributor to CO2 emission. To address this issue, we have embarked on reducing in 50% our mobile expansion concept, which replaces conventional massive injection plants with reusable ones storing energy in the subsurface. Here we propose to design a polymer injection project that is in line with circular economic concepts. We reduce the size of the needed facilities and reuse them by storing energy in the formation during injection periods (On) in half patterns and releasing it during shut-in periods (Off) in the other half of patterns. This mechanism is based on the high rock compressibility of the fluvial system in Manantiales Behr. Coupling the high rock compressibility with an On-Offcyclical injection strategy makes the system behave analogue to a spring-mass system that can store and release energy and has resonance conditions. We tested the idea in a conceptual simulator model, then in a sector model and finally, we implemented a pilot in four patterns that already had an oil response baseline by continuous polymer injection. Now, We expanded it to 14 patterns. We reduced more than 50% of the needs in steel consumption and the energy requirement for constructing and mounting a polymer injection unit. These savings amount to 170 to 405 tCO2 depending on the source of the steel which represents about 0.6% of the annual CO2 reduction per year in London. The incremental recovery factor is 19% incremental almost the same as continuous polymer injection. The reservoir simulations carried out show similarincremental recovery factors with this methodology than those that would be achieved with a massive injection for the same injection wells, achieving slightly lower production peaks, but with less decline and with polymer consumption 30% less than in the case of mass injection.On-Off injection strategy allowed us to feed a greater number of injectors with the same modular plant and reduce polymer consumption by not injecting massively into all the wells of the project at the same time. By Implementing this technology, we managed to reduce the environmental impact by lowering the number of modular injection plants needed and we improved the economics of the project by reducing both the CAPEX and OPEX involved. This process has a significant impact on all polymer flooding projects that are being undertaken in fluvial Complex Two of Comodoro Rivadavia Formation. Moreover, our mobile expansion concept with modular reusable plants (SPE-200355-MS) targets the installation of ten plants per year. Therefore, the potential reduction in emissions could be ten times greater.
No takes yet. Share an insight, caveat, or question.
Serrano et al. (2024) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: