Key points are not available for this paper at this time.
Temperature is very important in the fabrication of products developed for different applications, considering the widespread use of additive manufacturing (AM) technology. Thermal properties seriously affect the mechanical properties of products. In this study, the effect of printing nozzle temperature changes on the dimensional and mechanical properties of samples fabricated with acrylonitrile butadiene styrene (ABS) material was investigated. This material can be preferred over foam material for drone and model aircraft areas due to its low density. A total of thirty-six tensile test samples (ISO527–type1A) were fabricated with fused filament fabrication (FFF), one of the AM methods, and their dimensional properties (length, width, thickness, and mass) were determined. During the fabrication process, the nozzle temperature of the 3D (three-dimensional) printer was increased from 220 °C to 270 °C in 10 °C increments. All samples were subjected to tensile testing, and stress–strain values were measured. Analysis of variance (ANOVA) was applied to examine the effect of nozzle temperature change on the findings obtained as a result of the experimental study. The printing nozzle temperature significantly affected both the mechanical strength and dimensional properties of the samples. The samples showed lower viscosity and less hardness at higher nozzle temperatures. The mass and density of the samples decreased with increasing temperature. The tensile strength value decreased by 41.52%.
Ülkir et al. (Wed,) studied this question.