Key points are not available for this paper at this time.
Abstract This article presents the results of pilot studies on the lubrication of the blankholder zone in sheet metal forming using a pressurised lubricant. The authors invented a method and built a special tribometer for pressure-assisted lubrication. This approach reduces friction in sheet metal forming processes compared to conventional lubrication. Moreover, the artificial neural network approach combined with a force-directed Fruchterman-Reingold graph algorithm and Spearman’s correlation was used for the first time to analyse the relationships between the friction process parameters and the output parameters (the coefficient of friction and the resulting surface roughness of the sheet metal). The experimental tests were conducted utilising strip drawing on four grades of steel sheets known to be outstanding for deep-drawing quality. Different oils, oil pressures and contact pressures were used. Artificial neural network models were used for the first time to determine these relationships in a strip drawing test where every parameter is represented by one node, and all nodes are connected by edges with each other. R Software version 4.2.3 was used to construct the network using the ‘qgraph’ and ‘networktools’ packages. It was found that friction conditions had a highly significant negative correlation with coefficient of friction (COF) and a moderately significant negative correlation with the final surface roughness. However, the initial surface roughness of the as-received sheets had a negative correlation with the COF and a positive one with the resulting surface roughness of the sheet metal. The parameters most related to the COF are the strength coefficient, the ultimate tensile strength and the friction conditions (dry friction or pressurised lubrication). Spearman’s correlation coefficients showed a strong correlation between the kinematic viscosity and the friction conditions.
Najm et al. (Tue,) studied this question.