The Etching Effect Methods in Registration Properties on CR-39 Nuclear Track Detector

In this work, we use three different etching techniques—water bath, microwaves, and hotplate stirrer devices—in an effort to confirm the optimal etching time and conditions for tracks in the CR-39 solid-state nuclear track detector following irradiation to an alpha particle source (241Am). The research shows that the water bath’s maximum track density is 57596 tracks/cm2, appearing at 90 and 150 minutes. On the other hand, the hotplate stirrer’s maximum track density is 28050 tracks/cm2, appearing at 90 and 150 minutes. The microwave is the best etching method since it generated the tracks (65076 tracks/cm2) in a relatively short amount of time (10 min). The computation of the etching parameters, which are the bulk etch rates (V B ), track etch rate (V T ) and track etch ratio (V), was investigate in the etching properties. The time for the appearance of all traces of the microwave device is at a time of 10 minutes, followed by a hotplate stirrer at a time of 90 minutes, then a water bath at a time of 120 minutes.