Key points are not available for this paper at this time.
In order to overcome the defects that the multi-well typical curves analysis of shale gas reservoirs is rarely applied to engineering, this study proposes a robust production data analysis method based on deconvolution, which is used for multi-well inter-well interference research. In this study, a multi-well conceptual trilinear seepage model for multi-stage fractured horizontal wells was established, and its Laplace solutions under two different outer boundary conditions were obtained. Then, an improved pressure deconvolution algorithm was used to normalize the scattered production data. Furthermore, the typical curve fitting was carried out by using the production data and the seepage model solution. Finally, some reservoir parameters and fracturing parameters were interpreted, and the intensity of inter-well interference was compared. The effectiveness of the method was verified by analyzing the production dynamic data of six shale gas wells in Duvernay area. The results showed that the fitting effect of typical curves was greatly improved due to the mutual restriction between deconvolution calculation parameter debugging and seepage model parameter debugging. Besides, by using the morphological characteristics of the log-log typical curves and the time corresponding to the intersection point of the log-log typical curves of two models under different outer boundary conditions, the strength of the interference between wells on the same well platform was well judged. This work can provide a reference for the optimization of well spacing and hydraulic fracturing measures for shale gas wells.
Liu et al. (Fri,) studied this question.