Key points are not available for this paper at this time.
Ultrafast 3D ultrasound imaging is a rapidly growing research field that enables real-time imaging at a high frame rate and in a non-invasive manner. Currently, to achieve ultrafast 3D ultrasound, plane or diverging waves from virtual sources are used. These virtual sources can be considered as focal points during emission, allowing for improved transmission of ultrasonic energy. However, they have limitations in terms of transmitted energy, complex electronics, and timing issues, which impact the quality of the resulting images. To address this, a study was conducted to design and experiment with new miniaturized ultrasound transmitters based on cylindrical waveguides with tapered sections. These transmitters, with a diameter of approximately 100 μm, can replace the virtual sources. A numerical study based on 2D axisymmetric Finite Element Modeling (FEM) is first performed to model the transmission and reflection of longitudinal ultrasonic waves through various cylindrical rods. The results demonstrated that the transmission depends on the diameter ratio, frequency and longitudinal mode order (L0, L1, L2, etc.). An experimental study is then conducted on a stainless steel waveguide instrumented with 6mm piezo discs. The mechanical energy, estimated using Laser Doppler Vibrometer is transmitted through a 150 μm diameter rod, allowing mechananical focusing in the frequency range between 0.5 and 5 MHz. The application of this method to separate emission/reception transducers is then demonstrated for 3D ultrafast imaging.
Touré et al. (Fri,) studied this question.