Answers are grounded in this paper and cite their sources.
The use of secondary aggregates in the concretebases of road clothing is expedient from an economicand ecological point of view. The properties ofconcrete based on granite gravel, secondary crushedstone from reinforced concrete structures, secondarycrushed stone from brickwork and quartz sand werestudied. The type of sand was also changed: quartz,secondary from reinforced concrete structures,secondary from brickwork and ceramic tiles. Two seriesof samples were studied with the different amount ofPortland cement CEM II/B-S 42.5 N – 300 kg/m3 and350 kg/m3. A superplasticizer of the polycarboxylatetype was introduced into all compositions, the mobilityof all mixtures was 1..2 cm. The possibility of wide useof concrete based on secondary aggregates in thebases of rigid road clothing is shown.It was established that concrete based on secondarycrushed stone from reinforced concrete structuresand quartz sand has the greatest strength (up to 53MPa in compression and up to 3.8 MPa in tension inbending). The strength of such concrete is 2-6% higherthan the strength of concrete on granite gravel. Whenusing secondary crushed stone from brickwork andceramic tiles and quartz sand, compression strengthof concrete becomes lower by 7-15% comparing withconcrete on granite gravel. When using secondarycrushed stone from reinforced concrete structuressimultaneously with secondary sand, the compressivestrength of concrete decreases by 20-26%, and thetensile strength in bending decreases by only 2-7%.When using secondary crushed stone and sand frombrickwork and ceramic tiles, the compressive strengthof concrete is 44-56% lower than the strength of"control" concrete, the tensile strength in bendingis 20-21% lower. That is, concretes on secondaryaggregates are characterized by sufficiently hightensile strength in bending, which is important for theconcretes of the base of road clothing.The frost resistance of the tested concretes wasdetermined by the accelerated method. It wasestablished that for all concretes of both series, thelevel of frost resistance is F100. Thus, the actual levelsof strength and frost resistance of concrete obtainedin laboratory conditions on secondary aggregates areapproximately twice higher than the requirements ofDBN B.2.3-4:2015.
No takes yet. Share an insight, caveat, or question.
Чистяков et al. (2024) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: