Answers are grounded in this paper and cite their sources.
The manuscript describes a technique for fabrication and validation of a standalone handheld optical biosensor designed for non-invasive monitoring of glucose through saliva. In this cost-effective process, a 3D-printed glucose test strip was filled with sieving paste comprising of cellulose, polyethylene glycol (PEG), polyvinyl alcohol (PVA) and glycerol, onto which, glucose oxidase-peroxidase (GOD-POD) enzymes and 2,2′-azino-bis(3-ethylbenzothiazoline-6-sulfonic acid) (ABTS) chromogenic dye were co-immobilized. The enzymatic reaction produced H2O2 as by-product with which the ABTS reacted, leading to colour change on the detection zone of the strip which was detected by the developed glucometer. The in-house developed meter included an optically isolated section in its structure for inserting the strip to prevent interference from the ambient light conditions. The biosensor exhibited a broad detection range of 28–204 mg/dL of glucose concentration, with a sensitivity of 26.89 count/mg/dL and a limit of detection (LOD) at 28 mg/dL, within a response time of 120 seconds. The device along with strips was validated with clinical samples, comparing salivary glucose levels (SGL) to blood glucose levels (BGL) using a commercial glucometer i.e., Accu-Chek Active. Student's t-test on clinical data yielded p-values of 0.018, 0.01, 0.008, and 0.003 in fasting and post-prandial samples of non-diabetic and diabetic patients respectively, which represents a significant correlation. The device also passed Clarke's error grid analysis and is hence considered medically acceptable. The low-cost and simple-to-use saliva-based glucometer should be ideally suited for mass screening of diabetes as well as day-to-day health check-ups in a non-invasive and painless manner.
No takes yet. Share an insight, caveat, or question.
Panwar et al. (2024) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: