Answers are grounded in this paper and cite their sources.
Hands-on experiments to validate the theoretical concepts are essential for most of the Electrical and Computer (EE/COE) Engineering courses. The laboratory manual for these courses mostly requires students to construct the electronic circuit on breadboards and monitor the required response. But the electronic circuits within practical devices are fabricated on printed circuit boards (PCBs) and it is essential for EE/COE students to master the fabrication and troubleshooting process to enrich their measurement related training. This paper presents a methodology to include PCB fabrication and troubleshooting as the last step of selected experiments. The proposed method started with identifying an experiment with a relatively simple PCB layout. For a junior course laboratory on Analog Circuit Design, the experiment on "Single-stage amplifier design" was selected to introduce PCB fabrication and troubleshooting. The developed lab started with a prelab exercise, where students were asked to simulate the amplifier circuit designed earlier in the lecture section. They were asked to build the model and record the simulated operating point, input/output resistances, and the overall gain of the amplifier. Note that previous experiments are expected to teach the students how to effectively use the professional simulator needed for the prelab exercise. The lab started by comparing the calculated (from the lecture notes) and the simulated responses. Then the students collected the required components from the lab store and constructed the BJT amplifier circuit on the breadboard. Using the DC/AC sources, digital multimeter, and oscilloscope, the measured amplifier parameters were recorded and compared with simulated data. Finally, different methods of generating the PCB layout were introduced and students were asked to prepare the required PCB layout. The layout was implemented using either a PCB plotter or off-the-shelf PCB boards. Interestingly, all the students were highly motivated at this stage of the laboratory and actively took turns in placing and soldering the components on the PCB board. Although most of the circuit board worked during the 1st trial, some groups needed to troubleshoot to rectify the errors. As a bonus mark, students were asked to carefully de-solder the components without any damage. It was clear through the student survey that the inclusion of this last step made a huge difference in student participation and satisfaction.
No takes yet. Share an insight, caveat, or question.
Iqbal et al. (2024) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: