With the rapid expansion of urban areas, short naturally ventilated traffic tunnels (NVTTs) have become prevalent in modern cities. However, their enclosed design and inadequate ventilation often lead to the accumulation of vehicle emissions, especially during peak traffic periods, which poses significant threats to public health. Previous studies have shown that airflow in such tunnels is caused by ambient crosswinds (ACWs), which contribute to the dilution of pollutants. Based on this, a geometrical model including traffic tunnels belonging to a complex traffic system of the Second Ring Road in Wuhan City was established, followed by a mathematical model describing the fluid flow and pollutant transformation. The current flow characters and pollutant dispersion mechanism of CO and NOX were analyzed. Among them, the number and speeds of vehicles are measured to calculate the strength of the pollutant source. Then, the data was set as the initial contaminant source strength in Ansys Fluent 14.0 to compute the pollutant dispersion of the whole domain. The results indicate the following: (1) The airflow direction inside the tunnel varies with changes in ambient wind direction and wind speed. Specifically, variations in ambient wind direction result in changes in airflow direction in both tunnels. In contrast, changes in wind speed do not affect the airflow direction in both tunnels; only in the downstream tunnel does the airflow direction change with increasing westward wind speed. By comparison, in the upstream tunnel, the airflow direction remains unchanged regardless of the westward wind speed; (2) Pollutant accumulates along the downstream airflow in both the tunnels; (3) The mass fraction level of contaminate stratification differs along the tunnels. The pollutant tends to form y-component layering near the upwind opening and x-component stratification at the downwind opening of the two tunnels.
Cai et al. (Sun,) studied this question.