Introduction: The Coronal Plane Alignment of the Knee (CPAK) classification system categorizes nine phenotypes based on constitutional limb alignment and joint line obliquity. Understanding relationships between CPAK phenotypes and tibial slope could streamline total knee arthroplasty planning. This study investigated the correlations between CPAK classification and medial tibial slope in patients with osteoarthritis. Materials and Methods: A retrospective analysis of 622 cases in 535 patients with osteoarthritis undergoing primary total knee arthroplasty was conducted. Three-dimensional computed tomography imaging with MyPlanner® software determined mechanical lateral distal femoral angle, mechanical medial proximal tibial angle, and medial tibial slope. Statistical analysis included multiple linear regression, Pearson correlation, and one-way ANOVA with Tukey post-hoc testing. Outliers were removed using interquartile range criteria, resulting in 581 knees for final analysis. Results: Multiple linear regression revealed minimal correlation between coronal alignment and tibial slope (TS = 26.35 - 0.1045 aHKA - 0.1004 JLO; r² = 0.0233). Arithmetic hip-knee-ankle angle and joint line obliquity explained only 2.33% of tibial slope variance. Contour mapping demonstrated no discernible patterns in data distribution. Despite weak correlations, ANOVA identified statistically significant differences between CPAK groups for tibial slope (F = 2.97; P = 0.003). Tukey post-hoc analysis revealed significant differences between CPAK group I and groups V and VII, with mean differences ranging 1.39° to 2.06°. Conclusions: No clinically meaningful relationship exists between CPAK classification and tibial slope in osteoarthritic knees. While statistical significance differences were observed between certain CPAK groups, the extremely low correlation coefficient and small effect sizes indicate these differences fall within measurement variability and are substantially smaller than tibial slope variations that influence total knee arthroplasty outcomes. CPAK classification cannot reliably predict sagittal plane morphology, necessitating an independent, comprehensive three-dimensional assessment of coronal and sagittal characteristics during surgical planning.
León‐Muñoz et al. (Fri,) studied this question.