This study examines the mechanical response of medium-manganese TRIP steels under different stress states, focusing on deformation-induced austenite-to-martensite transformation and ageing phenomena. Two steels with distinctly different ferrite–austenite morphologies and retained austenite (RA) fractions were analysed: a globular microstructure with 18% RA and a lamellar microstructure with 14% RA, produced by single (SA) and double annealing (DA), respectively. Continuous and interrupted tests were performed under in-plane shear, uniaxial tension, and plane strain stress states. Strain fields were analysed using high-resolution digital image correlation, while RA fractions were quantified as a function of strain by ex situ X-ray diffraction. The results demonstrate a pronounced stress-state dependence. SA samples exhibit discontinuous yielding, with uniaxial tests showing clear Lüders band formation. Both steels exhibit dynamic strain ageing manifested by Portevin–Le Chatelier (PLC) serrations and associated strain bands, which are most pronounced under uniaxial tension, weaker in plane strain, and barely detectable in in-plane shear. Static strain ageing is also evidenced by a strengthened yield response upon unloading–reloading in all samples. The SA globular microstructure exhibits higher PLC band inclination angles than the lamellar DA microstructure, consistent with its more pronounced anisotropy. The propagation velocity in uniaxial tensile samples decreases with increasing strain following the work-hardening response. For both steels, the austenite-to-martensite transformation rate is highest in uniaxial tension, slightly reduced in plane strain, and strongly suppressed under in-plane shear. A Beese–Mohr/Johnson–Mehl–Avrami–Kolmogorov formulation incorporating stress triaxiality and Lode angle captures these trends for both steels. For the stress states considered, the DA condition exhibits a consistently higher transformation rate than the SA condition, accompanied by a higher work-hardening rate. These findings highlight the coupled role of stress state and microstructural morphology in governing localisation behaviour and strain-induced transformation in medium-manganese steels.
Carreno-Saavedra et al. (Mon,) studied this question.