What question did this study set out to answer?

The aim is to calibrate weather radars using electronically generated targets to enhance measurement accuracy.

February 8, 20260 citationsOpen Access

Calibration of weather radars with a target simulator

MSMarc Schneebeli ALAndreas LeuenbergerGamma Remote Sensing (Switzerland)PSPhilipp J. SchmidUniversity of Bern

Key Points

The aim is to calibrate weather radars using electronically generated targets to enhance measurement accuracy.
Calibration experiments were conducted with three radars: CHILL, SPLASH, and StXPol.
Artificial point targets were generated using a polarimetric radar target simulator.
A mobile lifting platform elevated the simulator for CHILL and SPLASH measurements.
Calibration of reflectivity and differential reflectivity variables was performed.
Data collection focused on minimizing multipath interference and ensuring target placement.
CHILL showed excellent stability with reflectivity bias under 0.2 dB over one hour.
SPLASH radar achieved good accuracy for Zdr and Zh under test conditions.
StXPol demonstrated high stability for Zdr; however, significant reflectivity bias was noted.
Precise calibration is feasible in ideal conditions with properly positioned targets.

Abstract

We present findings from radar calibration experiments involving three radars operated by the Colorado State University (CSU) in the US and by the École Polytechnique Fédérale de Lausanne (EPFL) in Switzerland. The experiments were based on the comparison between measured radar variables and the known properties of artificial point targets electronically generated with a polarimetric radar target simulator (RTS) from Palindrome Remote Sensing. Radars under test included the two magnetron-based radars CHILL and SPLASH (its mobile version) from CSU and EPFL's new solid-state radar StXPol. For the CHILL and SPLASH calibration measurements in Colorado, a mobile lifting platform was employed that elevated the target simulator instrument to approximately 15 m above ground. The creation of virtual targets with polarimetric signatures allowed for a direct calibration of polarimetric variables. While the SPLASH radar exhibited good Zdr and sufficient Zh accuracy, remarkable precision and stability were found in CHILL's reflectivity data time series, where the reflectivity bias compared to the virtual target was less than 0.2 dB over a 1 h time series. Calibration issues that arise with solid-state radar systems were investigated with experiments conducted with the EPFL StXPol radar. This pulse compression system transmits a linear frequency-modulated long pulse as well as a non-modulated short pulse for observations at close ranges. The two pulses are separated in frequency by 50 MHz, and consequently calibration targets were generated independently for the two channels. Excellent stability and accuracy were found for Zdr in both channels. While Zh stability was also very high, a large reflectivity bias in both the long and the short pulse channel was detected. For the first time, the article introduces and analyzes a weather radar calibration procedure that is based on electronically generated radar targets. Experimental data suggest that precise absolute and differential calibrations can be achieved if data are obtained in an environment free from multipaths and if the generated targets are precisely located in the center of the radar's range gate. Experimental shortcomings associated with limited sampling resolution of the radar scan over the targets are also investigated.

Demander à l'IA

Bookmark

View Full Paper