A Model of a Gravity Dam Reservoir Based on a New Concrete-Simulating Microparticle Mortar

To address the challenge that traditional dam model materials are difficult to simultaneously meet the requirements of microstructural similarity, dynamic damage simulation, and environmental friendliness, a novel microparticle mortar simulated concrete was developed. This new material consists of cement, sand, gypsum, mineral oil, water, and baryte sand. Through systematic material mechanical tests, the effects of each component on the material’s strength, density, and elastic modulus were revealed, and the optimal mix ratio was determined. This enabled precise control of low elastic modulus and had a high density, while the material is environmentally friendly, non-toxic, and compatible with direct contact with natural water. Its mechanical properties are highly similar to those of the prototype concrete. Based on a 1:70 geometric scale, a shaking table model test of the concrete gravity dam-reservoir system was conducted. The dynamic response and damage evolution under empty and full reservoir conditions were compared and analyzed. The study shows that this material can accurately simulate the stress-strain relationship and failure mode of prototype concrete. Under the full reservoir condition, the dam’s fundamental frequency showed only a 2.72% deviation from the numerical simulation, and as the seismic excitation amplitude increased, the changes in the fundamental frequency effectively reflected the accumulation of damage. Under the design seismic motion, the measured accelerations and stress responses for both empty and full reservoir conditions were in good agreement with numerical calculations. Under overload conditions, the acceleration amplification factor at the dam crest decreased with damage accumulation, and the dam neck was identified as the seismic weak zone. As the peak ground acceleration (PGA) increased from 0.15 g to 0.70 g, the fundamental frequency changes effectively reflected the damage accumulation process in the dam, while the hydrodynamic pressure at the dam heel showed a linear increase (457% increase). The experimentally measured hydrodynamic pressure distribution was between the rigid dam and elastic dam hydrodynamic pressures, reflecting the real fluid-structure interaction effect. This study provides a reliable material solution and data support for dam seismic physical model testing.