Answers are grounded in this paper and cite their sources.
Shows enhanced propylene selectivity in propane conversion using copper catalysts and CO2, indicating improved efficiency for industrial applications.
This study reports on the performance of alumina-supported copper-based catalysts in the oxidative dehydrogenation of propane, with copper dispersed on two distinct commercial aluminium oxide supports made of micro- and nanosized alumina, respectively. The activity and selectivity of the two catalysts was investigated at temperatures between 250 and 550 °C. At a propane-to-O2 ratio of 1:1, Cu/nanoAl2O3 achieves propylene selectivity of 35–48% at low temperatures (250–300 °C), while Cu/Al2O3 only exhibits activity starting at 350 °C with about 40% propylene selectivity. Altering the propylene-to-oxygen ratio to 3:1 enhances selectivity towards propylene in both catalysts, up to about 64% on Cu/Al2O3 at temperatures of 250–350 °C. The switch to the mild oxidant CO2 boosts propylene selectivity to 100%. In case of Cu/nanoAl2O3, the rate of propylene formation doubles that of the obtained with O2 used as oxidant. While with CO2 the Cu/nanoAl2O3 catalyst retains 100% propylene selectivity up to 500 °C, on the less active Cu/Al2O3 cracking sets off already at 400 °C. The different size of copper particles in the two catalysts is seen as a primary factor determining the observed differences in the performance of the studied catalysts.
No takes yet. Share an insight, caveat, or question.
Simkovičová et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: