Answers are grounded in this paper and cite their sources.
Evaluates a monitoring strategy for optimizing anaerobic digestion and dark fermentation in biogas production, suggesting enhanced efficiency.
Aiming at a sustainable energy production, 65 to 85% of biogenic residues in Germany are collected and used for mechanical or biological transformation. A share of it is applied for biogas production through anaerobic digestion in one of the approximate 9,000 biogas plants. If methanogenesis is prevented, the microbial conversion of biomass leads to the production of short-chain carboxylic acids in a process called dark fermentation. These products can be utilized as feed for the valorization in bioproduction. Lignocellulosic biomass is called recalcitrant due to its lignin content of 15-20% which is leading to difficulties in anaerobic digestion. Allowing high dry matter contents and loading rates, plug-flow based fermenter systems are of interest for the treatment of lignocellulosic biomass. Indeed, with radial mixing, a gradient formation can be achieved along the reactor length. The monitoring of this gradient formation has not been investigated so far. The evaluation of the efficiency of the processes is most often based mainly on the gas production, whereas the liquid phase, if monitored, is evaluated only at one randomly chosen spot. The work here describes strategies to increase anaerobic transformation of lignocellulosic feedstock based on the multi-position monitoring of the liquid phase in a plug-flow reactor and evaluates the potential implementation of decentralized processing. A 10L plug-flow reactor with 3 sets of on-line sensors monitoring pH, oxidoreduction potential and conductivity at the inlet, center and outlet parts was while digesting varying recalcitrant feedstock. The on-line monitored values were interrelated to off-line analyses for short-chain carboxylic acids content and chemical oxygen demand via Pearson’s correlation analysis. Results show that for the correlation analysis and successive forecast of the reactor performance, both single point measurements for pH, conductivity and ORP and the respective gradients are relevant to different extents. The various process conditions, e.g. dark fermentation, full anaerobic digestion and alterations in the power input are influencing the relevance of the monitoring at certain positions. Correlation analysis led to the assessment that monitoring at the center and outlet part of the reactor had the highest correlation to the off-line measurements. Thus, the on-line values gained from these positions could be used to replace off-line analysis effort, like short-chain carboxylic acid quantification. Therefore, multi-position monitoring of the liquid phase in plug-flow reactors allows an early detection of process failures and can help to achieve an increased feedstock flexibilization towards a higher share of lignocellulosic substrate.
No takes yet. Share an insight, caveat, or question.
Marion Longis (2025) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: