Answers are grounded in this paper and cite their sources.
Quantitative evaluation of P2H systems shows water-source heat pumps have the best performance, indicating greater efficiency for energy storage.
When Power-to-Heat (P2H) technology is integrated with Phase Change Material (PCM)-based thermal energy storage, it enables load shifting and peak shaving. This study quantitatively evaluates and compares the performance of P2H systems utilizing air-source, water-source, and ground-source heat pumps integrated with PCM thermal storage for a poultry house in Jeju. Dynamic simulations were conducted using TRNSYS, incorporating an empirically validated PCM tank performance model derived from previous thermal response analyses. The water-source heat pump system exhibited the best overall performance, with daily average coefficients of performance (COPs) of 3.0 for heating and 4.8 for cooling, and corresponding system-level energy consumption of 113.2 kWh and 62.4 kWh, respectively. The air-source heat pump displayed the lowest COPs, at 2.4 for heating and 2.3 for cooling, with system energy consumption of 107.2 kWh and 84.5 kWh. The ground-source heat pump system achieved the highest cooling COP of 5.1 and a relatively high heating COP of 3.1, with system energy consumption of 112.2 kWh for heating and 82.2 kWh for cooling. Although the ground-source heat pump demonstrated superior efficiency in HP-only performance, its total energy use increased due to additional circulation pump loads. The PCM-based storage tank exhibited significantly enhanced thermal storage capacity—69.0 MJ for heating and 55.0 MJ for cooling—approximately twice that of a conventional water storage tank, which has capacities of 32.5 MJ for heating and 27.7 MJ for cooling, thereby contributing to peak load reduction
No takes yet. Share an insight, caveat, or question.
Lee et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: