Answers are grounded in this paper and cite their sources.
Evaluates heat loss and collector efficiency in high-temperature cement kilns, suggesting methods for enhanced waste-heat recovery.
Radiative heat loss from cement rotary-kiln shells at 200–400 °C is a promising source for waste-heat recovery, but shell rotation prevents direct thermoelectric attachment and makes narrow-gap radiation–convection coupling the key constraint. This work develops a rotation-inclusive CFD framework using steady RANS with the SST k–ω model and gray surface-to-surface radiation to evaluate a non-contact radiative collector. The predicted outlet temperature is validated by on-site infrared thermography using a UNI-T UTi165B+ imager with an emissivity setting of 0.9 and an accuracy of ±2%. Experimental points are reported with error bars and assessed using a ±4% parity band. For a single collector plate, a speed-dependent regime is identified. The area-averaged plate heat-flux density is about 1378 W m−2 at zero rotation, remains within 1324–1359 W m−2 for ω ≤ 0.15 rad s−1, and decreases to about 1234 W m−2 at 0.30 rad s−1 as throat velocity rises and forced convection intensifies. For circumferential multi-plate installation, the radiative fraction stays nearly constant at about 41–45% with less than 1% variation, indicating that circumferential non-uniformity is governed by changes in absolute radiative load. An annular integrated collector is proposed to suppress bypass flow and stabilize the gap field. At L = 10 mm, rotation sensitivity is reduced and the circumferential temperature spread is about 1 K except near apex regions. A transition near L ≈ 18 mm is indicated by crown-side cooling and an inlet–outlet effect reversal, which provides a criterion for gap selection.
No takes yet. Share an insight, caveat, or question.
Tang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: