Answers are grounded in this paper and cite their sources.
Aqueous organic batteries using scCO2 show increased energy density and charge transfer in electrodes, indicating potential benefits for sustainable energy storage.
Aqueous organic batteries provide a sustainable and metal-free alternative to conventional electrochemical storage, with performance often limited by modest active material loading and incomplete utilization inside porous carbon hosts. We report a simple all-organic full cell in which supercritical CO₂ (scCO₂) impregnation loads halogenated quinones into activated carbon (AC) and reorganizes the interface in a way that accelerates charge transfer. Using a minimal formulation, 1,5-dichloroanthraquinone is incorporated at approximately 38 wt % loading in the quinone/AC composite (prior to binder addition) with full electrochemical utilization, corresponding to high-density filling of the micropores rather than a high overall active-mass fraction, and serving as evidence of effective pore accessibility. Micropore analysis indicates about 90% of a micropore-limited upper bound. Small-angle X-ray scattering shows an increase in the high-q electron density correlation length, consistent with strengthened π-π stacking and denser intrapore packing under supercritical conditions. We extracted interfacial electronic state information that can change with the impregnation route: comparative C K-edge X-ray absorption and X-ray photoelectron spectroscopy reveal core-level shifts consistent with a modified electronic environment and enhanced interfacial polarization in the scCO₂-impregnated samples relative to liquid-impregnated controls; confinement- and packing-related effects may also contribute. In aqueous full cells, the supercritical route gives a 60% increase in energy density and a clearly improved rate response relative to liquid-phase impregnation, while retaining 95% of the capacity after 1000 cycles; electrochemical impedance spectroscopy likewise shows a lower apparent charge transfer resistance for electrodes fabricated via supercritical impregnation, indicating faster interfacial kinetics. Taken together, these results demonstrate that scCO₂ impregnation promotes π-π-stacking-driven intrapore ordering and near-complete utilization in porous carbon quinone electrodes, translating nanoscale organization into device-level gains in a simple metal-free aqueous system.
No takes yet. Share an insight, caveat, or question.
Nakayasu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: