The unbalanced excitation of a rotor has a significant impact on the dynamic stiffness of the bearing. Traditional unbalanced excitation force models for the calculation of bearing stiffness are usually simplified as single-directional excitation models, which cannot fully reflect the impact of unbalanced excitation of the rotor on the dynamic stiffness of the bearing. A bidirectional excitation model based on orthogonal decomposition is used in this paper and is introduced into the finite element model of the bearing based on ABAQUS. The proposed bearing mechanics model is verified through numerical software and a bearing rotor system test rig. The effects of single/bidirectional excitation models on the dynamic stiffness of bearings were compared. The variation in bearing dynamic stiffness characteristics under rotor excitation and axial load were discussed. The results show that the presented model has good consistency with experimental results (the proposed model yields a maximum stress deviation of only 2.42% compared to MESYS numerical results and a maximum dynamic stiffness difference of 9.12% against experimental data). The traditional unidirectional excitation force model can only consider the influence of excitation frequency on the dynamic stiffness of bearings. However, the unbalanced excitation force model considering bidirectional excitation can further take into account the influence of excitation amplitude on the dynamic stiffness of bearings. Under the combined effect of excitation frequency and excitation amplitude, the radial dynamic stiffness of bearings shows a quadratic nonlinear hardening trend with rotational speed. As the rotational speed increases, the contribution of axial load to the radial stiffness significantly enhances: in the low-speed zone, its influence is only approximately 8%, while in the high-speed zone, it increases to 34%. Although the modeling method formed in this paper does not take into account the thermal–fluid dynamic coupling effect of the lubricating oil film, the obtained laws can provide a basis for the dynamic design of rotor systems of actual liquid rocket engines and have certain engineering application value.
Dou et al. (Tue,) studied this question.