Wheeled bipedal robots are promising for industrial mobility because they combine tight turning, agile balancing, and efficient rolling. Their inherently unstable and underactuated dynamics make reliable reference tracking challenging, particularly in the presence of sustained external disturbances and modeling errors. This paper presents a systematic modeling and control study using a three-degrees-of-freedom sagittal plane representation derived from the original six-degrees-of-freedom dynamics. Two linear tracking controllers are designed and compared: a full state feedback tracking controller and a linear quadratic servo controller with integral action. Practical performance is validated through real-time hardware in the loop simulation, where the controller runs on embedded hardware and the plant is executed on a real-time target including discrete time-sampling effects and analog input output communication noise associated with signal transmission. The results show that both controllers achieve stabilization, while the comparative HILS results reveal a trade-off rather than a uniformly superior controller. The full state feedback controller often yields lower finite-horizon position tracking errors, whereas the linear quadratic servo controller provides tighter body-pitch regulation and the more reliable removal of steady-state offset under sustained constant disturbances. These results demonstrate the feasibility of optimal servo control on cost-effective embedded platforms and indicate that controller selection should depend on the desired balance, considering tracking accuracy, disturbance rejection, convergence behavior, and actuator usage.
Noh et al. (Tue,) studied this question.