To address the challenge of autonomous process adaptation in non-standard components with continuously varying groove angles, this study proposes an intelligent decision-making framework based on Response Surface Methodology (RSM) for oscillation welding. Instead of solely identifying a single optimal parameter set, RSM is employed as a knowledge-modeling tool to reveal adaptive relationships between groove geometry and key welding parameters. A Central Composite Design (CCD) is utilized to establish predictive models for weld geometry under varying conditions: wire feed rate (8–12 m/min), travel speed (5–9 mm/s), travel angle (70–110°), oscillation amplitude (2–6 mm), dwell time (0.2–0.6 s), and groove angle (80–100°). The significance and adequacy of the models are validated through analysis of variance (ANOVA), demonstrating high predictive accuracy with all coefficients of determination (R2) exceeding 0.82. Furthermore, defect-aware physical constraints derived from the formation mechanism of bottom humping are incorporated into the optimization process, specifically restricting the travel angle to a push angle of 70–85° to ensure feasible and reliable decision outputs. Based on the established response surfaces, geometry-dependent parameter selection rules are derived to simultaneously optimize root penetration (target 8.5–10.5 mm) and sidewall fusion (>2.5 mm) for groove angles ranging from 80° to 100°. Experimental validation confirms that the proposed decision-making strategy achieves stable bead formation and defect-free fusion, demonstrating high quantitative reliability with root penetration prediction errors below 7% and bead width errors below 13%. This work bridges the gap between geometric perception and process control, providing a practical pathway toward intelligent and adaptive robotic welding of non-standard components.
Zhang et al. (Thu,) studied this question.