Thin polymer shell components used in consumer goods, the automotive industry, and marine applications are often produced by thermoforming. Depending on the quantity of parts, molding processes can increase throughput significantly when compared to processes such as milling or additive manufacturing. One disadvantage to mold-based manufacturing methods, however, is that molds must be produced to form the required geometry. Mold production is often complex and requires a large capital investment. For large-scale molding processes, mold production is sometimes complicated by the requirement for large working volume machine tools which are capable of machining the cavities to the appropriate tolerances for the selected molding process. This paper focuses on a segmented design for a large draw ratio (>3:1 molded surface area to sheet surface area) thermoforming mold and a cost-benefit analysis of segmentation versus monolithic design. Discussion of the thermoforming tests are included. The primary goals were to improve manufacturability and reduce the overall cost of the mold © 2026 The Authors. Published by ELSEVIER Ltd. This is an open access article under the CC BY-NC-ND license ( https://creativecommons.org/licenses/by-nc-nd/4.0 ) Peer-review under responsibility of the scientific committee of the NAMRI|SME. 1 Notice: This manuscript has been authored by UT-Battelle, LLC, under contract DE-AC05-00OR22725 with the US Department of Energy (DOE). The US government retains and the publisher, by accepting the article for publication, acknowledges that the US government retains a nonexclusive, paid-up, irrevocable, worldwide license to publish or reproduce the published form of this manuscript, or allow others to do so, for US government purposes. DOE will provide public access to these results of federally sponsored research in accordance with the DOE Public Access Plan ( http://energy.gov/downloads/doe-public-access-plan )
Betters et al. (Wed,) studied this question.