This is the authors' abstract. We don't add key points for this paper.
This study investigated the translucency of 3D-printed denture base resins modified with zirconium dioxide nanoparticles (ZrO₂NPs) under thermal cycling. A total of 110 specimens were fabricated and divided into 3 groups according to the materials, i.e., heat-polymerized resin, and 3D-printed resins (NextDent, and ASIGA). The 3D-printed resins were modified with 0, 0.5, 1, 3, and 5 wt.% of ZrO₂NPs. All the specimens were subjected to 5000 thermal cycles. The translucency was measured using a spectrophotometer. The results showed that the heat-polymerized resin had considerably higher translucency than the 3D-printed resins. Compared to the unmodified group, the translucency decreased significantly after adding 5% ZrO₂NPs to NextDent and 3% ZrO₂NPs to ASIGA resins. The highest translucency was achieved for NextDent by adding 0.5% ZrO₂NPs and for ASIGA without any ZrO₂NPs. It was found that the average concentration level in ASIGA was significantly higher than that in NextDent. These findings revealed that 3D-printed resins have lower translucency than heat-polymerized acrylic resin, and adding ZrO₂NPs at low concentrations did not affect the translucency of the 3D-printed resins. Therefore, in terms of translucency, 3D-printed nanocomposite denture base resins could be considered for clinical applications when ZrO₂NPs are added at low concentrations.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Khattar et al. (2022) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: