Answers are grounded in this paper and cite their sources.
The evolution and morphology of the confluences of model channels in a small flume were documented. Scour holes developed that were similar to features described at the confluences of branch channels in the braided North Saskatchewan River, North Platte River, and Medano Creek. The scour holes were maintained by turbulence and helicoidal flow cells generated by the converging flows; their depths and cross-sectional areas increase as turbulence increases. Scour hole depth increases rapidly as confluence angle increases from 15° to 90°, and more slowly up to 180°. Depth also increases as the difference between the discharges of the two confluent tributaries declines, and is a maximum when discharges are precisely equal. Depth decreases, other things being equal, as total sediment load increases. Apparently, an increase in sediment load requires an increase in shear stress for it to be transported, and therefore a constriction of flow and commensurate increase in flow velocity. Scour at the confluences of non-braided rivers may contribute to erosion of the bedrock surface during high flows. In one set of runs, in which tributary discharges and sediment loads were equal and held constant, and in which initial confluence angle ranged from 15° to 180°, final confluence angle was almost wholly determined by the initial conditions. There was thus no tendency for the confluences to attain an angle determined by the flow conditions, although erosion and deposition occurred at the bed and banks. The angle which each tributary made with the lower channel (equivalent to the angle of exit of the lower channel from the confluence) was related to the relative flow momenta of the tributaries. In a second series of runs, with confluence angle and tributary widths held constant at 60° and 6 cm respectively, a relative increase in discharge in one tributary caused the lower channel to swing into closer alignment with that tributary; at a given relative discharge, an increase in sediment load in one tributary had the same effect. However, computation of multiple regression equations indicated that exit angles were again closely related to the relative flow momenta. A third set of runs, in which tributary widths and discharges were varied, showed that, as discharge per unit width in one tributary increased over that in the other, the lower channel swung into closer alignment with the higher unit discharge tributary. The momentum equation can predict the angle of exit of the lower channel from a confluence if the overall confluence angle and tributary flow momenta are known. However, it is not possible to determine overall confluence angle in terms of hydraulic conditions, because it is an independent variable that itself controls flow processes in a confluence. It is partially determined by factors which cannot be dealt with by the principles of fluid mechanics, such as the characteristics of the surface upon which a drainage network was initiated, structure and lithology, and effectively random factors such as changes in channel orientation upstream of a confluence due to meander migration. To obtain a complete understanding of channel confluences, all such factors must be considered.
No takes yet. Share an insight, caveat, or question.
M. P. Mosley (1976) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: