Answers are grounded in this paper and cite their sources.
Lanthanum nanofibers were electrospun from a chemical sol calcined at 600 °C to obtain single-phase LaFeO₃ (LFO) perovskite. High-resolution transmission electron microscopy conjunction with 3D tomographic analysis confirmed an interwoven of hollow and porous (surface) LFO nanofibers. Owing to their surface area and p-type behavior, the nanofiber meshes showed chemoselectivity toward reducing toxic gases (SO₂,₂S) that could be reproducibly detected at very low concentrations(<1 ppm), well below the threshold values for occupational safety health. An increased sensitivity was observed in the temperature of 150–300 °C with maximum sensor response at 250°C. The surface reaction at the heterogeneous solid (LFO)/gas(SO₂) interface that confirmed the formation of La₂(SO₄)₃ was investigated by X-ray photoelectron. Moreover, the LFO fibers showed a high selectivity in detection of oxidizing and reducing gases. Whereas superior detection NH₃ and H₂S was measured, little response observed for CO and NO₂. Finally, the integration of meshes in commercial sensor platforms was successfully demonstrated.
No takes yet. Share an insight, caveat, or question.
Queraltó et al. (2019) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: