This is the authors' abstract. We don't add key points for this paper.
This study investigates the corrosion behavior of AlSi10Mg alloy produced by additive manufacturing and gravity casting before and after T6 heat treatment. Electrochemical tests showed that the additive manufactured material in as‐produced condition exhibits high corrosion resistance, due to the very fine microstructure, while immersion test allowed to identify an exfoliation‐like corrosion phenomenon, which caused a significant mass loss. In this case, T6 heat treatment was beneficial for corrosion resistance since the related change in microstructure led to a less detrimental corrosion mechanism. Therefore, the T6 heat treatment resulted necessary to use additive manufactured AlSi10Mg components in aggressive chloride‐bearing environments.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Girelli et al. (2019) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: