Answers are grounded in this paper and cite their sources.
The article presents comparative characteristics of the pore structure and sorption properties of raw halloysite (R-HAL) and after calcination (C-HAL) at the temperature of 873 K. Structural parameters were determined by optical scanning and transmission electron microscopy methods as well as by mercury porosimetry (MIP, Hg) and low-pressure nitrogen adsorption (LPNA, N₂, 77 K). The surface area parameter (LPNA) of halloysite mesopores before calcination was 54-61 m²/g. Calcining caused the pore surface to develop to 70-73 m²/g. The porosity (MIP) of halloysite after calcination increased from 29% to 46%, while the surface area within macropores increased from 43 m²/g to 54 m²/g. The total pore volume within mesopores and macropores increased almost twice after calcination. The course of CH₄ and CO₂ sorption on the halloysite was examined and sorption isotherms (0-1.5 MPa, 313 K) were determined by gravimetric method. The values of equilibrium sorption capacities increased at higher pressures. The sorption capacity of CH₄ in R-HAL was 0.18 mmol/g, while in C-HAL 0.21 mmol/g. CO₂ sorption capacities were 0.54 mmol/g and 0.63 mmol/g, respectively. Halloysite had a very high rate of sorption equilibrium. The values of the effective diffusion coefficient for methane on the tested halloysite were higher than De > 4.2 × 10⁻⁷ cm²/s while for carbon dioxide De > 3.1 × 10⁻⁷ cm²/s.
No takes yet. Share an insight, caveat, or question.
Pajdak et al. (2020) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: