Key points are not available for this paper at this time.
Abstract Global level assumptions of numerical models have received relatively less attention, but have been indicated to be a major source of error in numerical modeling of Reinforced Concrete (RC) structures. In parallel, it has been stated that a statistical approach involving many virgin specimens and ground motions is necessary for model validation. Such an approach would require very small‐scale testing. Then, the reinforcement fabrication becomes a major issue. This paper proposes using additive manufacturing to fabricate the reinforcement cage. It presents the results from cyclic tests on 1:40 RC cantilever members. The cages were manufactured using an SLM 3D printer able to print rebars with submillimeter diameters. Different longitudinal and transverse reinforcement configurations were tested. A numerical model using existing Opensees elements was built and its parameters were calibrated against material level small‐scale tests. It captured the cyclic response of the RC members with a reasonable accuracy. The cyclic behavior of the RC members resembles the behavior of full‐scale RC members indicating that such small‐scale specimens can be used for the statistical validation of the global level assumptions of numerical models.
Giudice et al. (Wed,) studied this question.