This article presents the experimental characterization of a 3D-printed conformal 2×1 microstrip array antenna designed for 2.4 GHz WiFi backscatter applications in indoor IoT scenarios. Starting from a planar configuration, three conformal states (30∘, 60∘, and 90∘) were realized to systematically evaluate the effect of bending. Detailed simulation and measurement results were obtained in terms of gain, efficiency, and radiation patterns, with the measured gain decreasing from 9.4 dBi in the flat case to 6.2 dBi at 90∘ bending. To evaluate the system-level impact of these measured gain variations, the measured power levels were incorporated into a TDMA-based WiFi backscatter link model, and the achievable bit transmission rate was assessed under practical indoor conditions, including line-of-sight (LoS), non-line-of-sight (NLoS), and residual interference effects. The main contribution of the work lies in combining the experimental validation of a fully 3D-printed RF-grade conformal antenna with a system-level WiFi backscatter assessment. The combined analytical–experimental results indicate that increasing curvature reduces the achievable maximum bit transmission rate and leads to earlier infeasibility under tighter quality of service (QoS) thresholds within the tested 2.4 GHz indoor WiFi backscatter conditions, suggesting that conformal geometry is an important design consideration for the studied setup.
Onay et al. (Tue,) studied this question.