The Zircaloy-4 alloy is a key structural material for nuclear reactor cores. However, its behavior under warm deformation conditions and during phase transformations requires in-depth investigation to improve technologies for producing ultrafine-grained (UFG) structures using severe plastic deformation methods. This work presents a comprehensive study of the rheological properties, phase stability, and microstructural evolution of the alloy in the temperature range from 20 to 950 °C at strain rates of 0.5 and 15 s−1. The experimental part included plastometric testing, dilatometric analysis, and microstructural characterization. It was established that the optimal window for plastic deformation corresponds to warm deformation at 650 °C. Dilatometric analysis confirmed that heating to 650 °C ensures the preservation of a stable initial α-phase structure, since the formation of secondary phases and the α→β transformation are initiated at higher temperatures, namely 694 °C (onset) and 847 °C (completion). At 650 °C, the deformation resistance decreases by approximately 70% compared to cold processing, while the strain-rate sensitivity of the flow stress is minimized. EBSD analysis showed that deformation under these conditions leads to intensive grain fragmentation via mechanisms of dynamic recovery and the initial stages of continuous dynamic recrystallization. The decisive role of the kinetic factor was demonstrated: reducing the strain rate to 0.5 s−1 promotes the formation of a finer and more homogeneous grain structure. In contrast, high strain-rate deformation (15 s−1) results in coarser grains and increased non-relaxed intragranular residual stresses. The obtained results provide a physical basis for optimizing thermomechanical processing regimes and can be used to produce UFG structures in zirconium alloys without the risk of phase degradation.
Popov et al. (Thu,) studied this question.
Synapse has enriched 5 closely related papers on similar clinical questions. Consider them for comparative context: