Hydro-Mechanical Weakening and Failure Mechanisms of Rock–Fill Composite Slope Interfaces under Intense Rainfall

Rock–fill composite slopes formed during the transition from underground to open-pit mining in metal mines are highly susceptible to interface hydraulic weakening and sudden sliding under intense rainfall, mainly due to the permeability contrast between the two media. Taking the Shizhuyuan Mine as a case study, a coupled hydro-mechanical numerical model was developed in ABAQUS 2025 to investigate slope stability under different rainfall patterns and interface strength degradation scenarios. The spatiotemporal evolution of seepage and deformation fields was examined in detail, with particular attention given to the variation of the safety factor, the distribution of pore water pressure along the interface, and the characteristics of interface slip. The results show that: (1) the deterioration of the hydraulic condition within the slope is governed by the water-blocking effect of the interface and the infiltration threshold of the surface layer. Under the same total rainfall, prolonged low-intensity rainfall is more likely than short-duration intense rainfall to produce sustained deep infiltration, and the factor of safety decreases from the initial 1.369 to 1.173 (0.005 m/h, 288 h) and 1.255 (0.02 m/h, 72 h), respectively, indicating that the former exerts a more pronounced weakening effect on slope stability. (2) Slope instability exhibits a clear interface-controlled pattern. Regardless of the degree of parameter degradation, the base of the plastic zone consistently develops along the rock–fill interface, accompanied by extensive plastic deformation within the overlying fill material. (3) Failure initiates at the slope toe where the mechanical equilibrium along the rock–fill interface is first disturbed. Under the combined influence of topographic conditions and the water-blocking effect of the interface, rainfall infiltration tends to converge toward the slope toe and form a local high-pore-pressure zone, resulting in a marked reduction in the effective normal stress at the interface. Once the local shear stress exceeds the shear strength, yielding is triggered first at the slope–toe interface, which then induces plastic deformation in the overlying fill material and ultimately leads to overall slope instability.