Cermet tools possess favorable mechanical and tribological properties and are widely adopted for machining hard-to-cut materials. However, their performance can further be enhanced with different cooling and lubrication techniques. In this study, the tool wear mechanisms of cermet tools during hard turning of AISI 4340 alloy steel are investigated under dry and minimum quantity lubrication (MQL) environments to identify the prevalent causes of tool failure through comprehensive analysis of tool wear progression, chip temperature, and chip morphological analysis. The results revealed that the application of MQL exhibited prolonged and stable steady-state tool wear progression with retained cutting-edge geometry, thus demonstrated 30.27% improvement in tool life compared to dry cutting. On the contrary, a rapid increase in tool wear due to excessive friction and higher thermal load is noticed with dry cutting in the absence of any heat-dissipating medium. Chip temperature measurements supported these observations, as chip temperature increases sharply from 358 °C (with a fresh tool) to about 1090 °C (with a worn tool) under a dry environment. Conversely, with MQL, the corresponding increase was in the range between 294 °C and 843 °C with a fresh and worn tool, respectively. Chip analysis revealed a serrated type of chip morphology. Dry cutting exhibited intensified feed marks, indicative of severe tool–chip friction, whereas MQL demonstrated smoother morphology with closely spaced saw-tooth patterns. Tool wear mechanisms indicate abrasion, adhesion, and edge chipping as dominant wear mechanisms under both environments; however, in the absence of any lubricant, these mechanisms were more intensified with higher crater formation.
Jouini et al. (2026) studied this question.