This study aims to enhance the damage controllability and overall seismic resilience of assembled underground structures under earthquake actions. To achieve this, three types of prefabricated roof–sidewall composite joints are proposed based on the design concepts of cogging for force transfer and local strengthening. These include the high-strength bolt–cogging–grouting sleeve joint (HCG), the prestressed steel strand–cogging–grouting sleeve joint (PCG), and the UHPC–cogging–grouting sleeve joint (UCG). Following the principle of positioning joints in regions of low structural stress, four 1/4-scale reinforced concrete (RC) specimens were designed and fabricated, including one cast-in-place (CIP) reference specimen and three precast RC specimens. Quasi-static tests were carried out to systematically evaluate the seismic behavior and internal force distribution of each specimen. Numerical validation was also performed using ABAQUS. The results show that both UHPC and a reasonable application of prestressing can effectively inhibit crack initiation and damage propagation at the joint seams. When the composite joints are positioned outside the plastic hinge region, they provide a reliable load transfer path for the reinforcement. The HCG and UCG joints significantly enhance the load-bearing capacity and energy dissipation capacity of the specimens. Their ductility and energy dissipation both achieve a seismic performance equivalent to that of the CIP specimen. Furthermore, damage in these specimens is predominantly confined to the designated plastic hinge region of the roof. This effectively mitigates shear damage in the roof–sidewall connection zone (RSC). Although the PCG joint improves the initial stiffness of the specimen, its energy dissipation capacity and ductility are reduced. It also causes damage to be transferred to the RSC. This leads to increased shear deformation and premature shear failure in this zone. Consequently, both UHPC and a reasonable application of prestressing can be used for the prefabrication of underground structures. Positioning the joints outside the roof plastic hinge zone can effectively achieve the seismic design goal of “strong joint, weak component”.
Shen et al. (Wed,) studied this question.