This is the authors' abstract. We don't add key points for this paper.
Steel processing units designed to work at elevated temperatures are invariably lined with different grades of expensive refractory material. During refining and processing of liquid steel, lining material progressively erodes due to chemical attack by slag, mechanical wear due to fluid flow or softening and spalling of the lining due to high temperature as well as thermal shock. Naturally therefore, beyond certain number of heats, relining of steelmaking vessels becomes essential. This is a routine and important operation in steel melt shop and profoundly influences the economics of steelmaking since relining of vessels (e.g., furnaces, ladles, torpedoes, tundishes etc.) is both time and cost intensive. Refractory performance is therefore an issue of concern to the steelmakers. Apart from chemical and thermal phenomena, hydrodynamics play important role and influence refractory wear. For example, high velocity regions prevalent in the vicinity of rising argon plumes lead to preferential localized wear of refractory lining in refining ladles. This is so as intense flow coupled with high degree of turbulence enhances mass transfer of various reactants and products to/from the refractory surface and thereby aid chemical attack. Similarly, strong turbulent flows can also cause higher penetration of the chemically active iron oxide, causing deterioration of refractory lining. Any reasonable velocity gradient produces requisite wall shear stresses and helps dislodge weakened refractory grains causing localized erosion of the lining material. In such context, it is important to investigate the role of fluid dynamics and the resultant distribution of wall shear stresses in steel processing units. As high operating temperatures, relatively large size of steelmaking reactors and visual opacity of molten steel pose serious limitations to direct experimental observations, a three dimensional, two-phase, turbulent flow model has been developed to predict wall shear stress distribution in gas stirred vessels. Furthermore, to demonstrate the predictive capability of the model and study quantitatively the impact of gas injection rates on wall shear stress distributions, results thus obtained have been assessed against previously reported experimental observation of Ballal and Ghosh. In the subsequent sections, mathematical modeling, computational results together with their comparisons with previously reported experimental data are presented.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Singh et al. (2008) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: