This is the authors' abstract. We don't add key points for this paper.
This study introduces a novel direct heating (DH) method for immobilizing Cu₂O and CuO nanomaterials onto kanthal coils, offering a scalable and efficient approach to photocatalyst synthesis. The coil achieved 100 % surface coverage within 4–8 min heating duration. Both the Cu₂O and CuO phases are present, and each has a narrow band gap, making them effective reductive photocatalysts. The CuO/coil prepared at 40 W heating power for 8 minutes exhibited Cu₂O particles (1666.67 ± 727.78 nm) and CuO rods (77.77 ± 19.08 nm in diameter), achieving a 21.01 % degradation efficiency for RhB dye under UV light. Despite agglomeration of Cu₂O particles limiting active sites, this method demonstrates simplicity and rapid synthesis compared to conventional techniques. Reusability tests revealed a decline in removal efficiency to 13.24 % after three cycles, attributed to photocatalyst detachment and dye accumulation on active sites. Addressing these challenges with improved adhesion and surface optimization could enhance long-term performance. The DH method shows strong potential for industrial wastewater treatment, offering a cost-effective and scalable solution for degrading organic pollutants. • The coil achieved 100 % surface coverage within 4–8 min heating duration. • Both the Cu₂O and CuO are narrow band gap semiconductor, making them effective reductive photocatalysts. • It demonstrated positive removal on the RhB dye. • DH method offers rapid and low cost approach for potential upscale synthesis.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Koe et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: