Porous glycidyl methacrylate-based copolymers crosslinked with ethylene glycol dimethacrylate (EGDMA) and trimethylolpropane trimethacrylate (TMPTMA) were synthesized via suspension–emulsion polymerization and subsequently functionalized with triethylenetetramine. The effect of the monomer composition on the epoxy group content and porous structure was systematically investigated by varying the GMA-to-crosslinker molar ratio from 1:1 to 5:1. Increasing the GMA fraction enhanced the epoxy group content (2.8–5.0 mmol/g) but significantly reduced the specific surface area (333–23 m2/g), indicating a trade-off between functionality and porosity. ATR-FTIR and elemental analysis confirmed successful amine functionalization while preserving a considerable degree of porosity. The modified copolymers were evaluated for Cr(VI) removal, showing strong pH dependence, with maximum efficiency at pH 3 due to electrostatic interactions between protonated amine groups and HCrO4− ions. Equilibrium studies revealed saturation-type behavior, with a maximum sorption capacity of 165.47 mg/g for TMPTMA-based copolymers. Despite the higher nitrogen content in EGDMA-based materials, TMPTMA-crosslinked copolymers exhibited a superior adsorption performance, demonstrating that pore accessibility, rather than functional group density alone, governs adsorption efficiency. These findings provide insight into the rational design of amine-functionalized porous polymer sorbents for efficient chromium(VI) removal.
Maciejewska et al. (Wed,) studied this question.